Questo sito web utilizza i cookie. Utilizzando questo sito, acconsenti all'utilizzo dei cookie. Per ulteriori informazioni, dai un'occhiata al nostro politica sulla riservatezza.

Le immagini servono solo come riferimento,

Vedi Specifiche Tecniche

DSPIC33FJ32GP304-I/PT +BOM

Fast execution speed for demanding signal processing tasks

Produttore:

Microchip Technology, Inc
ProduttorePart #:

DSPIC33FJ32GP304-I/PT
Scheda dati:

DSPIC33FJ32GP304-I/PT Scheda dati (PDF)
Series:

dsPIC 33F
Packaging:

Tray Alternate Packaging
Operating-Temperature:

-40°C ~ 85°C (TA)
Number-of-I-O:

35
EDA/CAD Modelli:

Richiedi modelli CAD gratuiti per DSPIC33FJ32GP304-I/PT

DSPIC33FJ32GP304-I/PT Descrizione generale

dsPIC dsPIC™ 33F Microcontroller IC 16-Bit 40 MIPs 32KB (32K x 8) FLASH 44-TQFP (10x10)

Caratteristiche principali

Operating Range
Up to 40 MIPS operation (at 3.0-3.6V)
3.0V to 3.6V, -40ºC to +150ºC, DC to 20 MIPS
3.0V to 3.6V, -40ºC to +125ºC, DC to 40 MIPS
High-Performance dsPIC33FJ core
Modified Harvard architecture
C compiler optimized instruction set
24-bit wide instructions, 16-bit wide data path
Linear program memory addressing up to 4M instruction words
Linear data memory addressing up to 64 Kbytes
Two 40-bit accumulators with rounding and saturation options
Indirect, Modulo and Bit-reversed addressing modes
16 x 16 fractional/integer multiply operations
32/16 and 16/16 divide operations
Single-cycle multiply and accumulate (MAC) with accumulator write back and dual data fetch
Single-cycle MUL plus hardware divide
Up to ±16-bit shifts for up to 40-bit data
On-chip Flash and SRAM
Direct Memory Access (DMA)
8-channel hardare DMA
Up to 2 Kbytes dual ported DMA buffer area (DMA RAM) to store data transferred via DMA
Most peripherals support DMA
Timers/Capture/Compare/PWM
Up to five 16-bit and up to two 32-bit Timers/Counters
One timer runs as a Real-Time Clock with an external 32.768 kHz oscillator
Input Capture (up to four channels) with Capture on up, down or both edges
16-bit capture input functions
4-deep FIFO on each capture
Output Compare (up to four channels) with Single or Dual 16-bit Compare mode and 16-bit Glitchless PWM mode
Hardware Real-Time Clock/Calendar (RTCC)
Interrupt Controller
5-cycle latency
118 interrupt vectors
Up to 49 available interrupt sources
Up to three external interrups
Seven programmable priority levels
Five processor exceptions
Digital I/O
Peripheral pin Select functionality
Up to 35 programmable digital I/O pins
Wake-up/Interrupt-on-Change for up to 21 pins
Output pins can drive from 3.0V to 3.6V
Up to 5V output with open drain configuration
All digital input pins are 5V tolerant
4 mA sink on all I/O pins
System Management
Flexible clock options: External, crystal, resonator and internal RC
Fully integrated Phase-Locked Loop (PLL)
Extremely low jitter PLL
Power-up Timer
Oscillator Start-up Timer/Stabilizer
Watchdog Timer with its own RC oscillator
Fail-Safe Clock Monitor
Reset by multiple sources
Power Management
On-chip 2.5V voltage regulator
Switch between clock sources in real time
Idle, Sleep, and Doze modes with fast wake-up
Analog-to-Digital Converters (ADCs)
10-bit, 11 Msps or 12-bit, 500 Ksps conversion:
Two and four simultaneous samples (10-bit ADC)
Up to 13 input channels with auto-scanning
Conversion start can be manual or synchronized with one of four trigger sources
Conversion possible in Sleep mode
Other Analog Peripherals
Two analog comparators with programmable input/output configuration
4-bit DAC with two ranges for analog comparators
16-bit dual channel 100 Ksps audio DAC
Data Converter Interface (DCI) module
Codec interface
Supports I2S and AC.97 protocols
Up to 16-bit data words, up to 16 words per frame
4-word deep TX and RX buffers
Communication Modules
4-wire SPI (up to two modules) with I/O interface to simple codecs
I2C™ with Full Multi-Master Slave mode support, slave address masking, 7-bit and 10-bit addressing, integrated signal conditioning and bus collision detection
UART (up to two modules) with LIN bus support, IrDA® and hardware flow control with CTS and RTS
Parallel Master Slave Port (PMP/EPSP)
Programmable Cyclic Redundancy Check (CRC)
Debugger Development Support
In-circuit and in-application programming
Two program breakpoints
Trace and run-time watch

Microchip Technology, Inc Stock originale

Specifiche

Product Category	Embedded - Microcontrollers	Series	dsPIC 33F
Packaging	Tray Alternate Packaging	Operating-Temperature	-40°C ~ 85°C (TA)
Number-of-I-O	35	Speed	40 MIPs
EEPROM-Size	-	Core-Processor	dsPIC
RAM-Size	4K x 8	Program-Memory-Type	FLASH
Peripherals	Brown-out Detect/Reset, DCI, DMA, I2S, POR, PWM, WDT	Connectivity	I2C, IrDA, LIN, SPI, UART/USART
Voltage-Supply-Vcc-Vdd	3 V ~ 3.6 V	Core-Size	16-Bit
Program-Memory-Size	32KB (32K x 8)	Data-Converters	A/D 13x10b/12b
Oscillator-Type	Internal	Tags	dsPIC33FJ32GP304, dsPIC33FJ32GP3, dsPIC33FJ32GP, dsPIC33FJ32G, dsPIC33FJ3, dsPIC33FJ, dsPIC33F, dsPIC33, dsPIC3, dsPIC, dsPI, DSP
Programmabe	Not Verified	Core Processor	dsPIC
Core Size	16-Bit	Number of I/O	35
Program Memory Size	32KB (32K x 8)	Program Memory Type	FLASH
EEPROM Size	-	RAM Size	4K x 8
Voltage - Supply (Vcc/Vdd)	3V ~ 3.6V	Data Converters	A/D 13x10b/12b
Oscillator Type	Internal	Operating Temperature	-40°C ~ 85°C (TA)
Mounting Type	Surface Mount	Base Product Number	DSPIC33FJ32GP304

Politiche di servizio e altro

Relativi al servizio post-vendita e alla liquidazione

Pagamento

Metodo di pagamento

TT/bonifico bancario

PayPal

Western Union

Grammo dei soldi

Per canali di pagamento alternativi, contattaci a:

[email protected]

Spedizione e imballaggio

metodo di spedizione

Fedex

UPS

DHL

NTN

Imballaggio

AVAQ determina e confeziona tutti i dispositivi in base ai requisiti di protezione contro le scariche elettrostatiche (ESD) e il livello di sensibilità all'umidità (MSL)..